UAS Sentry Touch Screen V4 Documentation

Primary Controls

Reset: Instant shutdown when on battery power. Reboots when externally powered.
Enter / Next: Advances screens, confirms selections, and locks portions of the touchscreen (long press).
Alarm Switch: Down = Enabled | Up = Silenced.
Status LED: Green = GPS lock / clear airspace Yellow = Awaiting GPS Red = Drone inside geofence
Power: Press to power on or off.
If GPS lock is unavailable, the iOS app may relay the phone’s GPS coordinates to the receiver.

Wi-Fi connectivity enables cloud synchronization, remote monitoring, and dashboard access via UasSentry.com.
To connect the Touch Screen V4 to a Wi-Fi network:
From the Radar screen, press Next to access the menu.
Select Config WiFi.
Choose a 2.4 GHz Wi-Fi network from the list.
Enter the network password.
The device will connect and automatically reboot.
• The V4 supports 2.4 GHz networks only. • Up to five (5) Wi-Fi networks may be stored. • Wi-Fi is required for cloud functionality but not required for local drone detection.
Once connected, the device will securely transmit detection data to the UAS Sentry Cloud platform.

Once initialized, the Radar screen confirms active Remote ID scanning. Detected drones automatically populate flight data and pilot location (if broadcast).

Use the next button to scroll through a variety of screens to get more information including QR codes that can be scanned to get drone & pilot location.
Real-time flight telemetry
Geofence alert activation
Cloud synchronization (if connected)

Dedicated 2.4 GHz receiver (on right)
Dual 2.4 / 5.8 GHz receiver (on left)
Optional extended-range stick antennas
Typical rural detection range: up to 1 mile (button antennas). Extended range available when using included high-gain antennas.

Go to the screen after the Radar screen and tap next (or push next button on the right side of the unit).
Tap the Config Wifi button.
The unit will take a few seconds looking for 2.4G wifi networks.
Enter the number which correpsonds to the network you want to connect to.
You will be prompted for the password. Enter the password.
Unit will attempt to connect to wifi. If succesful a success message will be displayed and the unit will then restart. This wifi network is remembered and will be used to connect to the UAS Sentry cloud.
Note: You need to connect to a wifi network (or use IOS app) to use the UAS Sentry cloud.
You may enter up to 5 wifi networks and they will be remembered.

Quick Start Mode significantly reduces system boot time for rapid field deployment.
When enabled, the device significantly reduces how long the startup initialization screens are shown.
To enable Quick Start Mode:
From the Radar screen, press Next.
Select Opts.
Scroll to Quick Start.
Enter 1 to enable.
• Default boot time: Approximately 60 seconds • Quick Start boot time: A few seconds • Recommended for routine operational use • Disable only when troubleshooting GPS or receiver initialization
Quick Start Mode is ideal for public safety, corrections, critical infrastructure, and rapid-response deployments.

The full suite of features on the UAS Sentry Cloud are available for two years.
After two years you may continue to use them for an annual fee of $295 (subject to change).

If you decide not to renew after year #2 you will still be able to use the IOS app and also use the unit in local mode. Local mode will give you full access to all the features that are running on the device including getting the locations of the drone and the pilot.

The Touch Screen V4 is a passive Remote ID receiver. It does not transmit, interfere, or mitigate aircraft.
Operation subject to FAA, state, and local regulations.